1.
Rotate the protective top.
2.
Insert the non-combusted tobacco cartridge upright into the chamber, leaving the filter protruding.
3.
Press and hold the button for 1.5 seconds until the LED light starts flickering blue and the device vibrates for the first time. The device starts preheating; the duration of the preheating phase is 15 seconds.
When the LED light turns steady blue and another vibration occurs, you can start enjoying the consumption for 4 minutes and 45 seconds.
When the consumption time reaches the last 30 seconds or the 13th inhalation, the device will vibrate for the third time and the LED light will start to flicker, indicating that the heating period is approaching its end.
When the entire smoking time elapses or 15 inhalations occur, the device will vibrate for the fourth time and the LED light will switch off, indicating that the entire heating process is complete.
4.
Push the left button up and the non-combusted tobacco cartridge will spring out of the cartridge holder. Remove the non-combusted tobacco cartridge and rotate the top.
Connect the USB cable to the charging adapter. The LED light can flicker in different colours, indicating battery power. When the device is fully charged, the LED light turns off.
Blue: 100% -60%
Yellow: 60% 10%
Red: 10% – 0%
Make sure that the device is switched off and cold before cleaning it. Detach the top from the main body of the device. Pull the heater part out of the main body of the device. Slide the cartridge holder through the left button and pull it out. Pull out the parts (cartridge holder and heater parts), then use the cleaning stick to clean the heating chamber.
