1.
Remove the ISMOD holder from the charger.
2.
Insert a cartridge of non-combusted tobacco in the ISMOD holder.
3.
Press and hold the button for 1,5 seconds until the ISMOD holder vibrates. The holder will start a preparatory heating of the non-combusted tobacco cartridge.
4.
Wait for 15 seconds, until the device vibrates again, indicating that the process of preparatory heating of the non-combusted tobacco cartridge is finished.
5.
A blue light will appear and stay steadily on, indicating that you can start using it. After 12 inhalations, the ISMOD holder will vibrate and the blue light will start to flicker. After 14 inhalations, the ISMOD holder will vibrate again and stop working.
6.
Pull the protective top upwards, together with the cartridge of non-combusted tobacco.
7.
Take the cartridge of non-combusted tobacco out of the protective top.
Warning: When removing the top after use, pay attention to the warning signs on the insulation, inside the ISMOD holder. The protective should be gently returned to the starting position in order to prevent damage to the protective top itself and the ISMOD holder.
End of use
A.
If you want to stop using the device before the end of the process, press and hold the button for 3 seconds. ISMOD holder will stop working and turn itself off; the indicator light will turn off and you will feel the device vibrating.
B.
After the device was used under normal operating conditions, the ISMOD holder generates a vibrating sound and its indicator light flickers. Then, the device turns off.
C.
After use, place the ISMOD holder back on the charger to charge, so that the device can be ready for the next use.
Note: Under normal operating conditions, if the amount of aerosol is significantly reduced, or the taste of the aerosol is impaired, it means that the non-combusted tobacco cartridge has been used up and the non-combusted tobacco cartridge needs to be replaced.
Instructions on how to charge the charger
A.
It is recommended that you charge the charger before the first use, in order to ensure normal device operation.
B.
When you are ready to charge the charger, plug one end of the charger cable into the USB port of the charger and the other end into the power connector.
C.
While charging, the battery indicator flickers at regular intervals until the charging is complete and the indicator light is steadily on.
Instructions for filling the ISMOD holder
A.
Before charging the ISMOD Holder, you must make sure that the charger is charged and has enough power.
B.
After finishing each individual cartridge of non-combusted tobacco, you have to refill the ISMOD holder before another use.
C.
During the charging process, you have to connect the charging port of the ISMOD holder to the charger. The device’s magnetic function will connect the device automatically and start charging.
D.
The corresponding charge indicator of the ISMOD holder will light up during the charging process. A red flickering light indicates that charging is in progress, while a blue steady light indicates that the charging is complete.
E.
After the ISMOD holder is fully charged, the indicator automatically turns off.
The product itself comes with a cleaning and maintenance kit for the ISMOD holder and the protective top.
When cleaning the ISMOD holder, remove the ISMOD holder protective top. Rotate the cleaning brush several times, then pull out the brush and remove any residue from the brush. After that, finish the cleaning process by using cotton swabs. .
